Skip to main content

Liquid Epoxy Type E

Force-cure Epoxy for Superior 3-layer Corrosion Protection

Liquid Epoxy Type E

Coating continuity.

Improved cathodic disbondment resistance.

Superior force cured epoxy.

Saves time.

Canusa Liquid Epoxy Type E is a force cured, two part epoxy used as the primary layer with Canusa 3-layer systems, such as GTS-PE.

Usage of Canusa’s proven method of force curing enables the installer to “pre-inspect” the joint prior to sleeve application. This provides the assurance that the pipe is fully protected and it will not be displaced and exposed to corrosive contaminates during the aligning and shrinking stages of the sleeve installation. It is composed of a specially formulated 100% solids epoxy system, which does not use any volatile solvents. This ensures that the thickness of the epoxy layer does not change as it cures.

Coating Continuity

The Liquid Epoxy Type E layer offers equivalent corrosion protection to the FBE primary layer in 3 layer polyethylene and 3 layer polypropylene mainline coated pipelines.

Improved Cathodic Disbondment Resistance

Liquid Epoxy Type E will improve the Cathodic Disbondment resistance results for hotmelt type adhesives when compared against bare steel substrate.

Superior Force Cured Epoxy

Using Canusa’s proven method of force curing the epoxy to the steel allows the installer to “pre-inspect” the joint prior to sleeve installation.

Saves Time

The improved chemical bonding that is achieved from the adhesive to the force cured epoxy layer allows for reduced sleeve installation times due to lower heat requirements.


Oil & Gas
Offshore Pipelines
Repair & Rehab
High Temperature